Are you looking for a router for your IoT applications?
-
4G
-
Primary
Batteries -
IP67
-
MQTT, MQTT(s)
-
Sensor
Management
The needs of local authorities vary depending on their regions and the geopolitical situation of each town or city. Some needs are recurrent, such as public lighting, electric vehicle charging stations, pollution monitoring, refuse collection or parking, others are county-specific such as the health monitoring of public conveniences or connected benches for homeless population in India. Regardless of the application, connected urban furniture must be covered by the network.
The MTX-StarSensor is an innovative and powerful solution for the most demanding monitoring applications (pumping stations, tank filling based on demand and electricity price, flow measurement, distribution of water through channels, and regulation of gates, monitoring of tanks, and land for crops, etc.).
The IP67 enclosure allows it to be used in any environment regardless of dust, humidity or water. Thanks to MTX-Tunnel firmware with improved Ultra Low Power, primary batteries with up to 10 years of autonomy, and power management features, the device can handle one analog sensor for years, without the need for external power. The modem has the ability to record data, which can be stored locally or sent remotely via 4G.
Look no further, Webdyn’s solutions are the best for your projects.
Enter the “ethernet” or “modem” connection type:
For an ethernet configuration, make sure the IP parameters are compatible with server access according to the concentrator local network configuration. For an ethernet connection, the configuration must be compatible with the concentrator’s local network topology so that it can access the servers. This configuration is done from the “Networks” configuration page (see section 3.2.2.3: “Networks”).
For a modem connection, the modem configuration must be correct before a connection can be set up. This configuration is done from the “Modem” configuration page (see section 3.2.2.4: “Modem”).
The parameters for the servers to be configured are at least the following:
Therefore the following fields need to be configured: “Interface”, “Type”, “Server type”, “Address”, “Port”, “Login” and “Password”.
The other fields can be left at the default values subject to the directories having been properly created beforehand. See section 3.1.2: “Configuration files” for more details.
Wait. The concentrator will reboot using its factory configuration.
