Suchen Sie etwas anderes?
Scenario details:
- 8 dry contact sensors need to be monitored
- In the event of an activation in any of them, a voice call must be made to several phone numbers
- The phone numbers that will receive the SMS alerts are +34666123456, + 34666123457 and +346661234568
- To avoid making a large number of voice calls (in case of rapid changes in a certain entry), a timeout of 5 minutes should be established per entry, that is, no more than 1 call will be made in a 5-minute window by activating a certain input
Solution: MTX-Tunnel firmware + MTX-IOT-S [4-N]
Configuration example (config.txt file) for the indicated scenario:
| Configuration | Observations |
| MTX_pin: 0000 MTX_model: 199802407 MTX_mode: none SMS_allPhones: off SMS_validPhone1: +34666123456 SMS_validPhone2: +34666123457 SMS_validPhone3: +34666123458 ALARM_smsNumber1: +34666123456 ALARM_smsNumber2: +34666123457 ALARM_smsNumber3: +34666123458 GPIO_mode0: input GPIO_config0: call;1;300 GPIO_mode1: input GPIO_config1: call;1;300 GPIO_mode2: input GPIO_config2: call;1;300 GPIO_mode3: input GPIO_config3: call;1;300 GPIO_mode4: input GPIO_config4: call;1;300 GPIO_mode5: input GPIO_config5: call;1;300 GPIO_mode6: input GPIO_config6: call;1;300 GPIO_mode7: input GPIO_config7: call;1;300 |
PIN if it has one Device model Gateways used Phone numbers Phone number 1 Phone number 2 Phone number 3 Phone number 1 Phone number 2 Phone number 3 GPIO0 configured as input GPIO0 call configuration GPIO1 configured as input GPIO1 call configuration GPIO2 configured as input GPIO2 call configuration GPIO3 configured as input GPIO3 call configuration GPIO4 configured as input GPIO4 call configuration GPIO5 configured as input GPIO5 call configuration GPIO6 configured as input GPIO6 call configuration GPIO07 configured as input GPIO7 call configuration |
Details:
- The configuration of the inputs as “call; 1; 300” indicates the following:
“call” > The input is configured to send alarm by voice call (the voice call will be made, but will not play any audio on the other end of the phone
“1” > The 2 indicates that the digital input is configured to make the voice call by activation of the input (when it closes taking it to ground)
“300” > Indicates the timeout of the digital input, in seconds. This means that, even if there are multiple changes in the digital input, there will never be more than 1 call in a 5-minute window (5 minutes = 300 seconds)
Enter the “ethernet” or “modem” connection type:
For an ethernet configuration, make sure the IP parameters are compatible with server access according to the concentrator local network configuration. For an ethernet connection, the configuration must be compatible with the concentrator’s local network topology so that it can access the servers. This configuration is done from the “Networks” configuration page (see section 3.2.2.3: “Networks”).
For a modem connection, the modem configuration must be correct before a connection can be set up. This configuration is done from the “Modem” configuration page (see section 3.2.2.4: “Modem”).
The parameters for the servers to be configured are at least the following:
Therefore the following fields need to be configured: “Interface”, “Type”, “Server type”, “Address”, “Port”, “Login” and “Password”.
The other fields can be left at the default values subject to the directories having been properly created beforehand. See section 3.1.2: “Configuration files” for more details.
Wait. The concentrator will reboot using its factory configuration.
