Suchen Sie etwas anderes?
Configuration for Connection
Before configuration, you should connect the router and your PC with the supplied network cable. Plug the cable’s one end into the Local Network port of the router, and another end into your PC’s Ethernet port.
The connection diagram is as following:
Please modify the IP address of PC the same as network segment address of the router, for instance, 192.168.1.9. Modify the mask code of PC as 255.255.255.0 and set the default gateway of PC as the router’s IP address (192.168.1.1).
Enter the “ethernet” or “modem” connection type:
For an ethernet configuration, make sure the IP parameters are compatible with server access according to the concentrator local network configuration. For an ethernet connection, the configuration must be compatible with the concentrator’s local network topology so that it can access the servers. This configuration is done from the “Networks” configuration page (see section 3.2.2.3: “Networks”).
For a modem connection, the modem configuration must be correct before a connection can be set up. This configuration is done from the “Modem” configuration page (see section 3.2.2.4: “Modem”).
The parameters for the servers to be configured are at least the following:
Therefore the following fields need to be configured: “Interface”, “Type”, “Server type”, “Address”, “Port”, “Login” and “Password”.
The other fields can be left at the default values subject to the directories having been properly created beforehand. See section 3.1.2: “Configuration files” for more details.
Wait. The concentrator will reboot using its factory configuration.
Esperar. El concentrador arrancará con su configuración de fábrica.
Warten Sie. Der Hub startet nach ein paar Augenblicken mit der Werkseinstellung neu.
Attendre. Le concentrateur va redémarrer avec sa configuration usine.
